Search results for "COMPOSITE COATINGS"
showing 4 items of 4 documents
Laser-induced damage in cold-sprayed composite coatings
2011
International audience; Ag-Ni composite coatings were achieved using the cold spray process. In this work, two blends were sprayed to lead to coatings with different mechanical properties, which corresponded to either a fine or a coarse microstructure. These coatings were studied using SEM and X-ray microtomography (XMT) to determine the best coating quality through characterization of particle-to-particle bonding. The fine microstructure showed better properties than the coarse microstructure. To avoid time-consuming characterization techniques such as SEM and XMT, an innovative laser characterization test was developed. The principle of this test is based on the thermal shock-induced by a…
Impact of Si on the high-temperature oxidation of AlCr(Si)N coatings
2022
The resistance of wear protective coatings against oxidation is crucial for their use at high temperatures. Here, three nanocomposite AlCr(Si)N coatings with a fixed Al/Cr atomic ratio of 70/30 and a varying Si-content of 0 at.%, 2.5 at.% and 5 at.% were analyzed by differential scanning calorimetry, thermogravimetric analysis and X-ray in order to understand the oxidation behavior depending on their Si-content. Additionally, a partially oxidized AlCrSiN coating with 5 at.% Si on a sapphire substrate was studied across the coating thickness by depth-resolved cross-sectional X-ray nanodiffraction and scanning trans-mission electron microscopy to investigate the elemental composition, morphol…
Laser Cladding of TiC for Better Titanium Components
2011
Pure commercial titanium is widely used because of its high corrosion resistance and lower cost compared with other titanium alloys, in particular when there is no high wear requirements. Nevertheless, the wear resistance is poor and surface damage usually occurs in areas under contact loadings. Laser cladding is a suitable technique for manufacturing precise and defect free coatings of a dissimilar material with higher wear and corrosion resistance. In this work a good understanding of laser metal deposition mechanisms allowed to obtain defect free coatings of Ti6Al4V and TiC metal matrix composite (MMC) using a flash lamp pumped Nd:YAG laser of 1 kW. A complete investigation of the proces…
Laser densification of organic coating: Effects of laser wavelength, operating parameters and substrate properties
2012
International audience; Mechanical bonding and interface behaviour play a key role for any materials deposited on different substrates. Usually, a post-spray heat treatment is required to improve the coating morphology and to enhance mechanical properties of thermal-sprayed polymeric coating. The effects of YAG, CO2 and diode laser radiations on as-sprayed PEEK coating deposited on stainless steel and aluminum substrates were investigated. The results revealed a good coating densification and interface behavior. A correlation between coating and substrate absorption coefficients, their thermophysical properties and laser operating parameters was shown. Besides, the finite element modeling b…